10 Apps To Help You Manage Your Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit however, it's still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is persistent or intermittent these tips will aid.
Water Damage
If you accidentally drop your key fob into the puddle, or it gets wet while kayaking canoeing, rafting, or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag every time you are outdoors or engage in activities that could expose it to large amounts of water.
It's also essential to make sure that the fob has dried out before you open the fob and then use it. If you notice any odors emanating from the fob like an industrial-like liquid smell or that of windshield washer fluid, this is another sign that it's submerged in water.
A circuit board that is wet could cause the battery to lose its charge, or even explode. If you are able to get your keyfob 308 out of the water it is best to turn the button side up and shake as much water as possible before opening the casing. After opening it, take off the battery, and then clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not function include a dead coin-cell battery or receiver module issues signal interference, or a defective chip. If none of the above is the issue, you can reset the system by disconnecting 12 Volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that lets drivers start their car from an extended distance, which allows them to warm up or cool down the car before they enter. This feature is extremely useful, especially in the cold winter months. However, there are times when the remote stop system stops functioning due to a variety of reasons, including the battery in the coin is dead.
The coin-shaped battery within the key fob may last between two and four years, based on the frequency with which it is utilized, the place it was purchased and how it is utilized. The date of use is typically written on the package or listed in the instruction manual.
If the key fob stopped functioning after exposure to clean tap water and you want to remove the battery, then clean the electronic chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If you expose it to salty or soapy water, the chip might be damaged and you'll need to replace the key fob completely.
If you are not sure the battery is in good condition you can check the voltage with a multimeter set to your vehicle's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts, it is time to replace the battery. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has created a fault. It's that part that sends an indication to the car when your key fob is activated, that also acts as an immobiliser. It stops it from starting unless the correct key is used.
This could be due to a number of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, like the chip that is located inside the device will be damaged. In this scenario it is necessary to take the unit apart and clean it thoroughly using isopropyl or electronic cleaner. When the battery is dry you can try it again.
If the issue continues to persist, it's probably a good option to consult an area Peugeot specialist or locksmith. They can use the diagnostic tool to pinpoint the issue and fix it.
Losing your Peugeot car keys could be a stressful experience. However, peugeot keys G28 qualified auto locksmith can address the issue in only a few minutes. They can cut a brand new key and then program it into your vehicle, making sure you can get back on the road again as fast as you can. Click here to find a locksmith near you.
Electronic chip malfunctions
The chip in the Peugeot 308 key fob plays a vital part in the remote control system. If it becomes damaged, your car might not start or receive a message stating "anti-theft active". In this situation, the only solution is to replace the key. Professional auto locksmiths can provide this service within the shortest possible time.
The chip in your Peugeot 308's key fob may fail due to various reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob has been exposed to soapy water, it is recommended to take it to the cleaners immediately. You can use a paper towel and isopropyl alcohol to wipe the electronic component. Then, you need to allow the battery to completely dry.
Sometimes the key fob may cease to function due to radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this problem, it is best to visit a Peugeot dealership.
The Peugeot 207/308 key fob is extremely delicate and requires care. It is not recommended to drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Remove the negative cable before the positive.